TTGO136
|
Bendable Steel Swivel Dash / Console Mount for Tomtom GO Devices
CM021-SB-2
Consumer Hotline:
(USA) (800) 841-0884
(INT'L) (626) 254-9005
Mon-Fri. 9am-5pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Made in Taiwan
© Copyright 2007 Arkon Resources, Inc.
The Mobile Mounting Specialists
TM
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and/or
air bag deployment.
Arkon Resources, Inc. is not responsible for any damages caused to
your car, your device, or yourself due to the installation or use of the
pedestal mount.
(G)
(H)
Step 1.
Step 2.
Attach the adapter plate by sliding it up into the slot on the back
of the Tomtom GO 520, 720, 920, or 920T device.
Follow the step from Pedestal Adjustment & Device Cradle
Attachment above.
Instructions for APTTGO520 Adapter Plate
Step 1.
Attach the device to the pedestal by inserting the dual T-tabs (G)
of the pedestal into the T-slots of the adapter plate (H).
for Tomtom GO 520,
720, 920, and 920T
APTTGO520
Removal of Dash Mount
To remove the dash mount completely, use a cotton swab dipped
in isopropyl alcohol. Simply peel up a corner of the dash mount
adhesive and swab under the pad while gently pulling until the
adhesive begins to release. Remove slowly. No damage will occur
from the adhesive if it has been properly installed and removed per
these instructions. You may see a slight discoloration between this
area and other parts of your dash due to fading caused by the sun.
Step 1.
Step 2.
Step 3.
Step 4.
Choose the best location on vehicle to place the mount.
Do not place mount in or near an air bag deployment zone or
where it will obstruct view of the road.
Clean o dash surface with alcohol cleaning pad and let dry. (A)
Do not attempt application of the dash mount if the temperature
is below 68
o
F (20
o
C).
Remove paper liner from adhesive on base (B) and ax adhesive
to the dash. Let stand (at room temperature) for
24 hours before using.
Adjust the angle of the pedestal head by bending the exible
metal strip (C). Rotate the strip and tighten the base cap. (D)
Pedestal Mounting
(B)
(A)
(C)
(D)
Pedestal Adjustment and Cradle Attachment
Compatible with:
t5PNUPN(05EFWJDFT
Comments to this Manuals